Delta MS 300 Series VFD is a ac drive (vfd) from Delta Electronics' industrial automation range (MS Series series), sold on order by Elume for the Indian market. Key data: motor rating 18.5 kW / 25 HP, amps 41.5 Amps, input voltage 460V AC, no of phase 3 Phase, height 300 mm, width 175 mm, depth 192 mm, keypad inbuilt NO. Price on request: add it to your cart and check out, and we confirm availability and price within 7 days by email; no payment is taken until you accept the quote. GST invoice on every order.
Select the drive by the motor's full-load current, not just kW, and make sure the drive's rated output current is equal to or higher than the motor's nameplate current. For heavy-duty loads like compressors, conveyors and crushers, choose a heavy-duty rating or one size larger.
Yes, a drive with single-phase 230V input and three-phase 230V output can run a three-phase motor wired for 230V (usually delta). Using a three-phase-input drive on single-phase supply needs heavy derating, so check the manufacturer's data before doing so.
Big savings come mainly on variable-torque loads like pumps and fans, where reducing speed reduces power roughly by the cube of the speed. On loads that run at full speed constantly, savings are small, though you still gain soft starting and process control (drives are covered by IEC 61800).
A VFD has built-in electronic motor overload protection, so a separate overload relay is usually not needed. A contactor or MCCB/fuses on the input side is used for isolation and short-circuit protection; do not switch a contactor between the drive and motor while the drive is running.
VFDs have high inrush current from capacitor charging and EMC filters that leak current to earth, which can trip sensitive 30mA RCCBs or B-curve MCBs. Use the input protection recommended in the drive manual, and Type B or higher-rated RCDs where earth leakage protection is needed.
A braking resistor is needed only when the load must stop quickly or the motor is driven by the load, such as in cranes, hoists or high-inertia fans. Without it, the drive may trip on DC bus overvoltage during fast deceleration.